loose fitting shotgun
I have an SKB trap gun imported by Ithaca which I have shot so much, i can feel some play when the breech is closed. I take it out and shoot it occasionally but I would feel better if I it fit tighter. Can this be repaired or should I hang it on the wall?
0
-
Those were nice shotguns. I'm reasonably sure it can tightened back up, though not a job for Bubba or a DIY project for most folks. 0 -
A competitive shooter told me years ago that SKB makes two or three oversize hinge trunnions , so the gun can be overhauled two or three times. His 600 was on the largest set so could not be tightened up again.
I don't know who to go to, but I bet they can be found.0 -
There is a outfit named Briley's, in Houston TX. They have been around a long time, and specialize in shotgun work. You might contact them. 0 -
Briley did my Browning about 5 years ago foe the same reason 0 -
Can be done by any good shotgun gunsmith. Call SKB with the model. I buy the parts from SKB and then take them to the gunsmith, saves all kinds of time and Frt. cost.
Or Briley. I also believe SKB will do the work if you call them.0
Please sign in to leave a comment.
Comments
5 comments