Shot question

DieHard4

November 24, 2015 14:33

I'm still unsure of this one. When we load shot, whatever the amount, 7/8 oz, 1 oz, and all the others, is this a volume measurement or a weight measurement, or both? I think it's a volume measurement, but ounces is a unit of measure for weight and volume, unlike say feet, which is length only. I know bullets measure in grains which is weight, so that is why I am confused. Especially when I have my adjustable Lee shot dipper.

0

• 

  charliemeyer007

  November 24, 2015 15:11

  Density is mass per volume. The size of shot matters in the calibration. Technically the volume for a shot charge is specific for each size. In practical use the volume occupied by 7.5's or 2's is close enough. If you fill in the voids of 9 00 with 8's you will have way more the 1.125 oz. the measure says.

  0
• 

  grizzclaw

  November 24, 2015 17:33

  I fill the shot cup to get a good crimp,then weigh the load. Magnum shot weighs less than chilled shot so in an oz and one eighth cup it weighs about an oz with # 7 shot,which is only a few pellets.

  0
• 

  XXCross

  November 25, 2015 07:11

  In machines using "shot bushings", the only accurate measure will be
  a load of number nine shot. (all others will be on the light side)
  As an example, one oz. bushing will discharge a one oz. load of #9 shot but not 6's or 4's. (they will be less)

  0
• 

  charliemeyer007

  November 25, 2015 10:18

  I have some bushing's for my DL Pacific press that are marked for both weight and shot size.

  0
• 

  XXCross

  November 25, 2015 10:51

  Size and weight ?
  
  Ah ! So we have progressed ?

  0
• 

  dakotashooter2

  November 25, 2015 12:42

  quote:Originally posted by XXCross
  
  In machines using "shot bushings", the only accurate measure will be
  a load of number nine shot. (all others will be on the light side)
  As an example, one oz. bushing will discharge a one oz. load of #9 shot but not 6's or 4's. (they will be less)
  
  
  As I understand it MEC labels bars calibrated for #9 shot as "skeet" bars and that their bars for larger shot probably have a slightly larger volume.
  
  There has always been some contention that, a volumetric measure of powder despite any minor weight discrepancy results in a similar velocity variation as a weighed charge.
  I just started loading some steel shot and have not bothered to go to the "steel" bars. I have taken existing lead bars and tested them for their steel capacity and marked them appropriately.

  0
• 

  243winxb

  November 26, 2015 06:10

  This is a big deal, if loading a 410, where every extra pellet is needed. quote:Magnum shot weighs less than chilled shot More pellets per 1/2 oz if using mag shot.

  0

Please sign in to leave a comment.