Skip to main content
Chat will be unavailable Friday July 3rd, in observance of the July 4th Holiday.
Help Center Community Shop

SIG 239 slide question

redman.com1
hello, I have a stripped sig 239 slide Im selling and assumed the 9mm and 40 would be the same? thing is I don't know what cal. this is for? can I just measure the opening? if so , anyone know what it would be for the 9 or .40? don't have a set of mics. just a tape. any help? thanks
0

Comments

10 comments

Date Votes
  • charliemeyer007
    Ask Sig what that frame serial # was made as/for.

    http://www.sigsauer.com/AboutUs/ContactUs.aspx
    0
  • redman.com1
    no number on it?
    0
  • rufe-snow
    The head size difference between 9mm and 40 S & W. Isn't that much,less than 1/32 of a inch. Tape isn't going to work. To measure that small a difference, your going to need a dial caliper. With I.D. measuring jaws.

    9mm is .390 +/- .005. 40 S & W is .415 +/- .005.
    0
  • redman.com1
    thanks ruff, red
    0
  • perry shooter
    If the slide still has the extractor installed and you have a 9mm and or a 40 Loaded cartridge just slide the cartridge up the face of the slide if it is a 9mm slide the 40 will be very hard to slide the cartridge under the extractor hook and if the slide is a 40 a 9mm case will fall out on it's own weight
    0
  • 62fuelie
    Or you can measure from the firing pin hole to the bottom of the extractor cut, it should be half the diameter of the case head +/-.
    0
  • redman.com1
    had it measured at .550 which is way too small for the .357 and my gunsmith tried a 40 cal. barrel from a 226 and was too large, so assuming 9mm?
    0
  • rufe-snow
    quote:Originally posted by redman.com1
    had it measured at .550 which is way too small for the .357 and my gunsmith tried a 40 cal. barrel from a 226 and was too large, so assuming 9mm?


    If you were referring to outside diameters of the barrel? In your original post? I misunderstood you. Thought you meant breech face dimensions.

    Can't help with Sig. But a 40 S & W. Model G 27 Glock, has a .590 diameter barrel at the muzzle. This pistol has also the ability of using .357 Sig, and 9mm Luger chambered barrels.
    0
  • 62fuelie
    I misunderstood,as well. I have both the .357 and .40 barrels for my P-239 they measure .550 OD. I don't have a 9mm to check, but wouldn't be surprised if it was the same.
    0
  • Bottom Gun
    I regularly swap barrels in my P239 and shoot 9MM, .357 Sig and .40 S&W with the same slide. I think your slide will work with any of the three calibers.
    0

Please sign in to leave a comment.

Recent Activity

Didn’t find what you’re looking for?