+ 3 1911
Bill
I checked the hooks and found them to be only .015"
I checked the hooks and found them to be only .015"
0
-
I have been watching This topic from the beginning with Interest . You are in good hands if you listen to Forgemonkey . Your post shows that when someone decides to build a pistol from unknown quality of parts that person can end up putting together a FRANKING- GUN that can kill the shooter or bystander. on the other hand Good quality Parts are much better to build as then everything will be easier to fit The first CLONE 1911 Frames were at best hit or miss I used to by 5 at a time and some were so bad Better to just make a paper weight out of them . 0 -
I going to start again with a different hammer and sear, plus taking time to make pins for use in checking sear engagement.
I visually checked the parts when I got them and since they looked OK put them with the slide and frame.
With the guidance of forgemonkey it has turned out was not a good idea without checking to be sure the parts meet specifications.
Thanks to forgemonkey for looking over my shoulder0 -
You are well on your way to understanding the difference between gun assembler and gunsmith. 0
Please sign in to leave a comment.
Comments
3 comments