High Standard Magazines

aldo35

June 29, 2016 08:00

Any general info on dates/models HS factory magazines came without name on base, silver tops, in the white etc.

0

• 

  aldo35

  June 29, 2016 08:00

  Has anybody had any experience with the TripleK magazines for the High Standard HD-Military? Are they any good.

  0
• 

  rufe-snow

  June 29, 2016 09:27

  High Standard pistols are prone to feeding problems, because there isn't a integral feed ramp in the barrel.
  
  They has caused me a lot of aggravation in the past. The very front portion of the rear lips, is where most of the problems originate. The spacing between the very front of the rear lips should be just under 3/16".
  
  You need a dial caliper that is able to measure I.D.'s to set them correctly. If the measurement is over 3/16, the bullets will hit the top of the chamber. Under 3/16 they will hit the bottom.
  
  I use needle nose vise grips, with jaws padded with duct tape. To compress the very front of the lips. If the bullets are going in high. The shank of a 3/16" drill to separate the front of the lips. If going in low.
  
  Also found out, that round nose solid .22 bullets. Feed much better than hollow points. In High Standards with cranky magazines.

  0
• 

  aldo35

  June 29, 2016 09:38

  Thanks, that is very helpful. I will give you an update.
  Aldo35

  0
• 

  TRAP55

  June 29, 2016 10:45

  http://highstandardpartsonline.com/High Standard Magazine Adjustments Models102-107 PTS1.pdf

  0
• 

  charliemeyer007

  June 29, 2016 12:24

  Nice tips guys. CCI work best in my HD Military. I have 5 magazines for it, 4 of which I tuned. I had Sport King with a 12" barrel someone put on. It cycled flawlessly and was wonderfully accurate. I sold it (sadly) when I got out of rim fires for the most part many years ago.

  0

Please sign in to leave a comment.