Wolff Springs for Blackhawk
The kit came with a mainspring, trigger spring, and a tiny spring. What's the tiny spring for? And how in the world do you compress the mainspring to get a cross pin the hammer strut??
-
Ruger New Model Blackhawk Parts | Numrich Gun Parts (gunpartscorp.com)
the diagram might help
0 -
base pin latch spring possibly. check here.
0 -
pulling the hammer back compresses the mainspring. small spring is for the cylinder pin latch, and you should install it. you will need a small flatblade screwdriver with a notch cut into the center of it to r&r the spring. go to popular video site to lern how to polish internals, this will really help.
3 -
On you tube there is a excellent video on disassembly and reassembly, helped me when I tore into my Blackhawk to change springs.
0 -
"pulling the hammer back compresses the mainspring." VARIAN: Yes, I got that. Put in a little cross pin and I'm good to go to take that assembly out of the gun. But now I have to remove the old mainspring and replace it with the Wolff.
Now, "how in the world do you compress the mainspring to get a cross pin in the hammer strut??"
0 -
you can use a small pair of needle nose pliers thru the spring coils and on either side of the strut. just compress a little, it really isn't too hard to get your disassembly pin out and back in. ive had the spring get away from me before, but have always found it.
0
Please sign in to leave a comment.
Comments
6 comments